承印物：ABS,PS,PC,有机玻璃,硬质PVC,发泡材质等 产品举例：塑玩具制品,家电塑胶外壳,塑胶铭牌,商标牌,有机玻璃表牌,常用透明聚苯(PS) ，加硬PC及强化PC。 二 产品特性： 1、亮光,色彩鲜艳,耐酒精,,高浓度,厚膜型,低气味,遮蔽性,附着力,硬度高(达到2H) 2、适用于丝印和移印工艺 3、产品细度:5um以下 三 使用说明： 1 丝印 网板：150—500目聚脂丝网印版 胶刮：建议使用65-85度聚氨酯胶刮 用量：350目网板印刷约为40㎡/kg 干燥: 自然干燥,表干7-20分钟,实干3小时以上或100℃以下热风吹干 2 移印 溶剂: SU1快干水,SU2慢干水,因印刷环境温度不同进行选择 清洗: 选用有机溶剂清洗（如：718,783） 用量：约为45㎡/㎏ 四 注意事项: 以上是以我司的测试结果,谨供参考。量产前务必在贵司的条件下,再次测试为盼。 五 产品包装: 1公斤装、5公斤装、20公斤装 六 储存条件: 5℃—25℃条件下可存放两年,避免强光照射,防接触强酸,强碱。
Substrate: ABS,PS,PC, Plexiglas, PVC, rigid, foam products, such as for example: plastic toy products, home appliances plastic case, plastic nameplates, trademark licensing, plexiglass sheets, transparent polystyrene (PS), hardened PC and enhance PC. II products characteristics: 1, and light, color bright, resistance alcohol, wear, high concentration, thick film type, low smell, covered sex excellent, adhesion excellent, hardness high (reached 2H) 2, and applies Yu silk printed and moved printed process 3, and products fine degrees: 5um following three using deion: 1 silk printed network Board: 150-500 accounts poly fat screen printed version glue scraping: recommends using 65-85 degrees polyurethane glue scraping dosage: 350 accounts Network Board printing about for 40 square meters/kg dry: natural dry, table dry 7-20 minutes, Work for more than 3 hours or up to 100 ℃ hot-air drying 2 printing solvents: SU1, quick-drying water, SU2 slow water, due to print, choose different ambient temperature cleaning using organic cleaning solvents (such as: 718,783) quantity: approximately 45 sqm/kg four-Note: the above is based on our test results and reference levels. Mass must be in your condition, testing again will be appreciated. Five packaging: 1 kg, 5 kg, 20 kg six storage conditions: 5 ℃-25 ℃ condition can be stored for two years, to avoid glare, prevent contact with strong acids, strong alkali.
