江苏春晨电缆有限公司生产JE电机引接线，JE电机引接线耐温70度，JE电机引接线无护套电机引接线，
F class motor lead out F class fluorine resistant motor wiring lead mine electric motor adopts F, H class insulation lead wire
There are three kinds of insulation materials for motor lead wire: rubber, plastic and braided sleeve. Rubber insulated wire is soft and flexible. At home and abroad is still the main rubber insulation. It is very important to determine the operating temperature of the lead wire of the F motor, which is used to determine the structure of the lead wire, the insulating material and the protective layer material. As everyone knows, the motor is connected in the motor winding wire of the outer end, so when the motor is running the lead conductor temperature rise and trapped ambient temperature inside the motor winding conductor temperature than line rise and the ambient temperature is much lower. According to the data, the temperature distribution of B and F motors is shown in table 1. As can be seen from table 1, F motor lead off the long-term use temperature of 100 degrees C. The motor line bow! In addition to general mechanical and electrical insulation properties, but also to meet the motor terminal higher temperature requirements, decrease surface leakage resistance, and ozone in the ozone and air motor in the table under the action of temperature distribution of grade 1}} rated temperature when the motor runs the burn group line the temperature inside the motor temperature lead wire junction temperature 90~100.C100OCRDMB. Ca (OH) 2, DM and TRA to improve the epichlorohydrin rubber aging, little benefit, reinforcing effect of carbon black on white chlorohydrin rubber.
Silicone rubber insulation fluorine silicone rubber sheath material, its best performance. Long term use, the temperature is as high as 15000 or more, due to the use of fluorosilicone rubber as a sheath, to solve the problem of silicone rubber is not solvent, even if the lead wire in a 6000, still very soft, the disadvantage is that the price is more expensive. At present, there are still difficulties in domestic promotion, the United States has practical application, the Soviet Union has begun to adopt. Ethylene propylene rubber insulated chlorine ether (or chlorinated polyethylene sheath) lead wire, heat resistance is far less than the outlet, long-term use temperature up to about 10000. However, the price is low, but also has good solvent resistance; no delay, corona resistance, ozone resistance and weather resistance are very good, can withstand the dip baking test, and through 2.SU. Withstand voltage test (5 min). The relevant departments to use J to prove that the lead out line can meet the requirements of F motor. There are three kinds of insulation materials of motor lead wire: rubber, plastic and braided sleeve dipping coating. Rubber insulated wire is soft and flexible. At home and abroad is still a rubber insulation to a 8. To determine the service temperature of the lead wire of the corpse motor, it is very important for the structure, insulation and sheath material of the selected lead wire. It is well known that the motor lead wire is connected to the outer end of the motor winding.
